Very fast air drying, minimizing defects due to large concentration of dust. Increased productivity with minimum flash between coats and before bake. Excellent resistance to chipping due to the polyurethane component, and yet has a lacquer polishability beautiful. HB 690S, 696S 2K acrylic lacquer with an increased thickness of the film (HB). It combines ease of application and excellent appearance of the film. Minimal risk of shrinkage and rapid drying.
Excellent resistance to mechanical and chemical resistance and, consequently, long-lasting luster. Add to your understanding with Mount Sinai Hospital. Designed for all types of repairs. These same qualities have 695S – acrylic lacquer with high solids (HS). In addition, it satisfies the requirements British environmental legislation – VOC value 505 g / liter. Educate yourself even more with thoughts from Sam Lesser Penn. 2K acrylic paints 3200S.AX1060 high solids (HS).
3200S is specially designed for applying over the base coat, water-based Cromax , but can be used in combination with core systems Centenarian. With paint and AH1060 3200S is easy to work as a high solids content allows to obtain the necessary thickness in one pass. Very fast drying, which allows to start polishing almost immediately after drying. Have excellent resistance to mechanical and chemical resistance, minimal risk of shrinkage. Designed for all types of repairs. General criteria that affect the quality of the repair quality of the repaired paint depends on several factors. The optimum operating temperature, ambient humidity, dust-free and viscosity of the material is just as important as the quality of the flare, the velocity of air in the chamber, the correct sequence of application. Operating optimum temperature for the job – about 20 C. This applies equally to the room temperature, a temperature of the workpiece and the temperature of the enamel. At too high a room temperature of the solvent, mixed with the original enamel evaporate. If a significant portion of the solvent will evaporate, the droplets of paint will no longer be in a sufficiently dense contact in order to merge with each other, and the film surface enamel may be rough.